Questions

What value is primarily used to determine which port becomes the root port on each non-root switch in a spanning-tree topology? A. path cost B. lowest port MAC address C. VTP revision number D ...

How is provided master redundancy on a stacked switches? A. 1:N B. N:1 C. 1:1 D. 1+N Correct Answer: A Explanation Explanation/Reference: 1:N master redundancy: Every switch in the sta ...

Which technology can enable multiple VLANs to communicate with one another? A. Intra-vlan routing using a layer 3 switch B. Inter-vlan routing using a layer 3 switch C. Inter-vlan routing using ...

Which three elements must be used when you configure a router interface for VLAN trunking? (Choose three.) A. one physical interface for each subinterface B. one IP network or subnetwork for each s ...

Refer to the exhibit. Which two statements are true about inter VLAN routing in the topology that is shown in the exhibit? (Choose two.) A. Host E and host F use the same IP gateway address. B. Th ...

What is true about Ethernet? (Choose Two.) A. 802.2 Protocol B. 802.3 Protocol C. 10BaseT half duplex D. CSMA/CD Stops transmitting when congestion occurs E. CSMA/CA Stops transmitting when ...

What field is consisted of 6 bytes in the field identification frame in IEEE 802.1Q? A. SA B. DA C. FCS D. SOF Correct Answer: A Would you like to boost your salary? The best way is looking ...

Which two of these statements regarding RSTP are correct? (Choose two) A. RSTP cannot operate with PVST+. B. RSTP defines new port roles. C. RSTP defines no new port states. D. RSTP is a propr ...

If primary and secondary root switches with priority 16384 both experience catastrophic losses, which tertiary switch can take over? A. a switch with priority 20480 B. a switch with priority 8192 ...

Which three options are switchport configurations that can always avoid duplex mismatch errors between the switches? (Choose three.) A. Set both side auto-negotiation B. Set both sides on half dup ...

Which VTP mode prevents you from making changes to VLANs? A. server B. off C. client D. transparent Correct Answer: C If you want to take the first step to success, you can choose BestCisco ...

On which type of port can switches interconnect for multi-VLAN communication? A. interface port B. access port C. switch port D. trunk port Correct Answer: D If you want to take the first s ...

Which IEEE standard does PVST+ use to tunnel information? A. 802.1x B. 802.1q C. 802.1w D. 802.1s Correct Answer: B Explanation Explanation/Reference: Cisco developed PVST+ to allow st ...

What is the default VLAN on an access port? A. 0 B. 1 C. 10 D. 1024 Correct Answer: B Explanation Explanation/Reference: If we configure an access port as follows: Switch(config)#int ...

Refer to the exhibit. A network associate needs to configure the switches and router in the graphic so that the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2. Which two ...