Questions

If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface? A. the IP address of the ...

The OSPF Hello protocol performs which of the following tasks? (Choose two.) A. It provides dynamic neighbor discovery. B. It detects unreachable neighbors in 90 second intervals. C. It maintain ...

The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command? (Ch ...

The Company WAN is migrating from RIPv1 to RIPv2. Which three statements are correct about RIP version 2? (Choose three.) A. It has the same maximum hop count as version 1. B. It uses broadcasts f ...

Which address is the IPv6 all-RIP-routers multicast group address that is used by RIPng as the destination address for RIP updates? A. FF02::9 B. FF02::6 C. FF05::101 D. FF02::A Correct Answ ...

In which situation would the use of a static route be appropriate? A. To configure a route to the first Layer 3 device on the network segment. B. To configure a route from an ISP router into a cor ...

Which two statements are true about the command ip route 172.16.3.0 255.255.255.0 192.168.2.4? (Choose two.) A. It establishes a static route to the 172.16.3.0 network. B. It establishes a static ...

Refer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.) ...

Refer to the exhibit. Which three statements are true about how router JAX will choose a path to the 10.1.3.0/24 network when different routing protocols are configured? (Choose three.) A. By default ...

Which three statements are correct about RIP version 2? (Choose three) A. It uses broadcast for its routing updates B. It supports authentication C. It is a classless routing protocol D. It has ...

Refer to the exhibit. After a RIP route is marked invalid on Router_1, how much time will elapse before that route is removed from the routing table? A. 30 seconds B. 60 seconds C. 90 seconds D ...

Which statement is true, as relates to classful or classless routing? A. Automatic summarization at classful boundries can cause problems on discontinuous subnets B. EIGRP and OSPF are classful ro ...

What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router? A. 2 B. 4 C. 16 D. Dunlimited Correct Answer: B Explanation Expla ...

Which pairing reflects a correct protocol-and-metric relationship? A. OSPF and number of hops and reliability B. EIGRP and link cost C. IS-IS and delay and reliability D. RIPv2 and number of h ...

Refer to the exhibit. Which two statements are true about the loopback address that is configured on RouterB? (Choose two.) A. It ensures that data will be forwarded by RouterB. B. It provides sta ...