Questions

Refer to the exhibit. Which two commands, when configured on router R1, fulfill these requirements? (Choose two.) Packets towards the entire network 2001:db8:2::/64 must be forwarded through router R2 ...

Which action does the router take as rt forwards a packet through the network? A. The router replaces the source and desinaoon labels wth the sending router uterface label as a source and the next ...

When a site-to-site VPN is configured, which IPsec mode provides encapsulation and encryption of the entire original P packet? A. IPsec tunnel mode with AH B. IPsec transport mode with AH C. IPsec ...

Which protocol requires authentication to transfer a backup configuration file from a router to a remote server? A. DTP B. FTP C. SMTP D. TFTP Correct Answer: B Have you learned this question ye ...

What is a function of the Cisco DNA Center Overall Health Dashboard? A. It provides a summary of the top 10 global issues. B. It provides detailed activity logging for the 10 devices and users on th ...

Where is the interface between the control plane and data plane within the softwaredefined architecture? A. control layer and the infrastructure layer B. application layer and the infrastructure lay ...

Refer to the exhibit. R5 is the current DR on the network, and R4 is the BDR.Their interfaces are flapping, so a network engineer wants the OSPF network to elect a different DR and BDR. Which set of c ...

Which level of severity must be set to get informational syslogs? A. alert B. critical C. notice D. debug Correct Answer: D Explanation Explanation/Reference: Specifying a level causes message ...

Refer to the exhibit. Router R4 is dynamically learning the path to the server. If R4 is connected to R1 via OSPF Area 20, to R2 via R2 BGP, and to R3 via EIGRP 777, which path is installed in the rou ...

After installing a new Cisco ISE server, which task must the engineer perform on the Cisco WLC to connect wireless clients on a specific VLAN based on their credentials? A. Enable the allow AAA Overr ...

Why was the RFC 1918 address space defined? A. conserve public IPv4 addressing B. preserve public IPv6 address space C. reduce instances of overlapping IP addresses D. support the NAT protocol Co ...

When a switch receives a frame for a known destination MAC address, how is the frame handed? A. sent to the port identified for the known MAC address B. broadcast to all ports C. forwarded to the f ...

Refer to me exhibit. Which action is taken by the router when a packet is sourced from 10.10.10.2 and destined for 10.10.10.16? A. It uses a route that is similar to the destination address B. It di ...

What is the function of a controller in controller-based networking? A. It serves as the centralized management point of an SDN architecture. B. It centralizes the data plane for the network. C. It ...

Refer to the exhibit. When PC-A sends traffic to PC-B, which network component is in charge of receiving the packet from PC-A verifying the IP addresses, and forwarding the packet to PC-B? A. Layer ...