Questions

Refer to the exhibit. Given the output from the show ip eigrp topology command, which router is the feasible successor? A. 10.1.0.1 (Serial0), from 10.1.0.1, Send flag is 0x0 Composite metric is ( ...

Which IPv6 routing protocol uses multicast group FF02::9 to send updates? A. static B. RIPng C. OSPFv3 D. IS-IS for IPv6 Correct Answer: B Explanation Explanation/Reference: Below list ...

Which command must you enter to enable OSPFV2 in an IPV4 network? A. ip ospf hello-interval seconds B. router ospfv2 process-id C. router ospf value D. router ospf process-id Correct Answer: ...

Which two steps must you perform on each device that is configured for IPv4 routing before you implement OSPFv3?(Choose two) A. configure an autonomous system number B. configure a loopback interf ...

Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B? A. The loopback addresses are on different subnets. B. The value of the dead timers on th ...

Refer to the exhibit . Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers? A. Network 172.16.1.32 mask 255.255.255.224 B. Network 172.16.1.0 0.0.0.255 C. N ...

Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1? A. The router will forward packets from R3 to R2 to R1. B. The rout ...

Which option describes a difference between EIGRP for IPv4 and IPv6? A. Only EIGRP for IPv6 advertises all connected networks. B. Only EIGRP for IPv6 requires a router ID to be configured under th ...

Which definition of default route is true? A. A route that is manually configured. B. A route used when a destination route is missing. C. A route to the exact /32 destination address D. Dynam ...

Which value must you configure on a device before EIGRP for IPv6 can start running? A. public IP address B. loopback interface C. router ID D. process ID Correct Answer: C Have you learned ...

Instructions: – Enter IOS commands on the device to verify network operation and answer the multiple questions. – THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION. – Click the device icon to gain ...

Which two statements about floating static routes are true? (Choose two) A. They are routes to the exact /32 destination address B. They are used when a route to the destination network is missing ...

Refer to the exhibit. If R1 sends traffic to 192.168.10.45, the traffic is sent through which interface? A. FastEthernet0/1 B. FastEthernet0/0 C. FastEthernet1/0 D. FastEthernet1/1 Correct A ...

Refer to the exhibit. If RTR01 is configured as shown, which three addresses will be received by other routers that are running EIGRP on the network? (choose three) A. 192.168.2.0 B. 10.4.3.0 C. ...

To enable router on a stick on a router subinterface, which two steps must you perform? (Choose two.) A. Configure an IP route to the VLAN destination network. B. Configure encapsulation dot1q. ...