Questions

Which two statements about MPLS are true? (Choose two.) A. It uses point-to-point physical circuits to provide logical full-mesh connections to the service provider. B. It requires a hub in a larg ...

Which specification supports full-duplex traffic only? A. 100BASE-TX B. 1000BASE-SX C. 1000BASE-TX D. 10BASE-T Correct Answer: B BestCiscoDumps is the best way to pass CCNA certification in ...

Which statement about switch ports is true? A. The default VLAN and native VLAN must be different on al ports B. VLAN 1 is preconfigured as the native VLAN on trunk ports only. C. VLAN 1 is prec ...

According to industry best practices, which length is the recommended maximum for a Category 6 cable in a 10GBASE-T environment? A. 37 meters B. 300 meters C. 100 meters D. 55 meters Correct ...

Which circumstance matches the description of an excessive collision? A. The same frame is sent sixteen times. B. The deferred counter value is greater than 1024. C. Bit 512 of the frame is sent ...

Which two statements about single and dual-homed links are true? ( choose two.) A. Single-homed connections to a service provider require OSPF or EIGRP. B. Dual-homed connections to multiple servi ...

Which two features can you enable on a switch to capture network traffic and measure performance? (choose two) A. ACL B. SPAN C. IP SLA D. STP E. SNMP Correct Answer: BE Are you still loo ...

When you configure and boot a new device, when does the running configuration become active? A. Immediately after the power-on self-test B. When IOS is loaded into RAM. C. When the devices boots ...

Which two statements about southbound APIS are true? (Choose two.) A. OpenFlow is a southbound API standard. B. They communicate with the management plane. C. They use HTTP messages to communica ...

Which action do you take to reset the VTP configuration revision number on a switch in VTP server made? A. Change the VTP domain name to any new value, and then change the name back to the original ...

Which commands can you can enter to verify that a router is synced with a configured time source? A. Show ntp associations B. Show clock details C. Show clock D. Show time E. Show ntp status ...

When a switch is running in VTP server mode, VLAN configuration information is stored in which file? A. vlan.dat B. startup-config C. vlan.config D. config.text Correct Answer: A Do you wan ...

You are configuring a 100-Mb fast Ethernet connection between a PC and Switch. Which action must you take to configure the speed one each of the two interfaces? A. Set the switch port to auto-negoti ...

Which two statements about private addresses are true? (Choose two.) A. By default, Class C private networks support up to 255 subnets. B. Network 192.168.25.0/28 supports 14 usable private host a ...

Which configuration register setting do you use to bypass the password that is stored in the startup configuration? A. 0xFFFF B. 1×2102 C. 0x2102 D. 0x2142 Correct Answer: D If you want to ...