Questions

A network administrator is troubleshooting an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval an ...

Which command can you enter to set the default route for all traffic to an interface? A. router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1 B. router(config)#ip route 0.0.0.0 255.255.255.25 ...

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric o ...

Which command can you enter to verify that a BGP connection to a remote device is established? A. show ip bgp summary B. show ip community-list C. show ip bgp paths D. show ip route Correct ...

Which three statements about link-state routing are true? (Choose three.) A. OSPF is a link-state protocol. B. Updates are sent to a broadcast address. C. It uses split horizon. D. Routes are ...

How are VTP advertisements delivered to switches across the network? A. anycast frames B. multicast frames C. broadcast frames D. unicast frames Correct Answer: B If you want pass CCNA cert ...

How can you manually configure a switch so that it is selected as the root Switch? A. increase the priority number B. lower the port priority number C. lower the priority number D. increase th ...

Based on the output below from SwitchB, which statement is true? A. The MAC address of the root bridge is 0017.596d.1580. B. The Fa0/11 role confirms that SwitchB is the root bridge for VLAN 40. ...

What are two reasons a network administrator would use CDP? (Choose two.) A. to verify the type of cable interconnecting two devices B. to determine the status of network services on a remote devi ...

A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and without decreasing network ...

What value is primarily used to determine which port becomes the root port on each non-root switch in a spanning-tree topology? A. path cost B. lowest port MAC address C. VTP revision number D ...

How is provided master redundancy on a stacked switches? A. 1:N B. N:1 C. 1:1 D. 1+N Correct Answer: A Explanation Explanation/Reference: 1:N master redundancy: Every switch in the sta ...

Which technology can enable multiple VLANs to communicate with one another? A. Intra-vlan routing using a layer 3 switch B. Inter-vlan routing using a layer 3 switch C. Inter-vlan routing using ...

Which three elements must be used when you configure a router interface for VLAN trunking? (Choose three.) A. one physical interface for each subinterface B. one IP network or subnetwork for each s ...

Refer to the exhibit. Which two statements are true about inter VLAN routing in the topology that is shown in the exhibit? (Choose two.) A. Host E and host F use the same IP gateway address. B. Th ...