Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two.)
A. All of the routers need to be configured for backbone Area 1.
B. R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3
C. A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
D. The hello and dead interval timers are not set to the same values on R1 and R3.
E. EIGRP is also configured on these routers with a lower administrative distance.
F. R1 and R3 are configured in different areas.
Correct Answer: DF
A is not correct because the backbone area of OSPF is always Area 0.
B is not correct because R1 or R3 must be the DR or BDR -> it has to establish neighbor adjacency withthe other.
C is not correct because OSPF neighbor relationship is not established based on static routing. It uses multicast address 188.8.131.52 to establish OSPF neighbor relationship.
E is not correct because configure EIGRP on these routers (with a lower administrative distance) will force these routers to run EIGRP, not OSPF.D and F are correct because these entries must match on neighboring routers:
– Hello and dead intervals
– Area ID (Area 0 in this case)
– Authentication password
– Stub area flag
Preparing for the Cisco exam should be based on your level of experience. Use BestCiscoDumps to prepare for the Cisco CCNA exam. They provide 100% real exam dumps that cover authentic exam questions. We offer the best training and services!